Cozy Warm Air Heater

The Darvall Cozy Warm Air Heater warms patients before, during, and after anaesthesia.  The air flow promotes even distribution of warm air throughout the blanket and onto the patient helping to improve patient outcomes and reduce the incidence of hypothermia.

Features & Benefits:

Warm your patients safely before, during, and after surgery

• Reduces anaesthesia recovery time
• Delivers consistent and even patient warming
• Enough power to warm two blankets at once
• Safe for surgery
• Hose-end temperature sensor for safety
• Simple display and user interface
• Lightweight, compact, mobile & stable
• Easy maintenance
• 3 fixed temperature settings
• 1 yr warranty

Includes:

• Additional Cozy Warm Air Heater Filter (replace after 500 hours of use)
• Vinyl covered delivery hose
• Hose Clamp secures to surgery table (sold separately)
• Built-in cage hangers
• Built-in rear-mounted IV Pole Clamp

Specifications:

Weight: 10 lbs (4.5Kg)
Dimensions:  11"H x 8.6"W x 8.7"L (13.5"H with wheels installed), Power cord 16 ft. length
Hose: <55dB
Recommended filter change: Every 500 hours of use
Recommended operating environment: 59°F to 77°F
Thermostat: Independent electronic circuit; thermal cutoff shuts the heater OFF to ensure hose end air remains below 127.4°F (127.4°F ± 5°F typical); back-up over-temperature detection at hose inlet.
Alarm System: Over-temperature (127.4°F ± 5°F typical): red Over-temp indicator light flashes, alarm sounds, heater and fan shut down, operating indicator lights turn OFF, control panel becomes unresponsive.
Fault: Fault information will display on the LCD, alarm sounds.
Over current protection: Dual input fused lines
Heating element: 1000W Resistive PTC
Leakage Current: Meets IEC 60601-1 requirements
Fan motor Operating speed: approximately 2900 rpm
No Load Airflow: 50cfm or 23 L/s
Power consumption
PEAK: 1500W AVERAGE: 750W
Device ratings
110-120V; 60Hz;12 A 30V; 50/60 Hz; 8A
Power cord
16 ft, 3 Cond, 13 A (110V)
Fuses
110-120V Darvall Cozy: 6c, 12A x 1; 5C, 12A x 2

Classification
Classified under IEC 60601-1 Guidelines (and other national versions of the Guidelines) as Class I, Type BF, Ordinary equipment, continuous operation. Not suitable for use in the presence of flammable anaesthetic mixtures with air or with oxygen or nitrous oxide.
Device Directive as a Class II device (US FDA)

Note: The Darvall Cozy rating is 110-120V OR 220-240V & cannot be used simultaneously in both voltage ranges. Please refer to SN label on the Darvall Cozy Heater to confirm correct voltage.

24 months warranty (unit only does not include hose)